Design Guide

18
Cabinet Opening Dimensions HC 1540, HC 1541, HCB 1560, HCB 1561
Inset cabinet Depth D Frameless cabinet Depth D
24" + panel thickness 24"
Concerning the refrigerator compartment there is the op-
tion to choose between stainless steel panels for a 80”
or a 84” installation situation.
When using your own custom overlay panels, only the
80" opening minimum would apply. Opening height can
be taller than the 80" minimum by any amount but be
sure to adjust panel height accordingly.
IMPORTANT
Factory available stainless steel panels are designed for
an inset installation only and require a cabinet / gable
depth of 24 - 3/4".
IMPORTANT
Do not install the shut-off valve for the
water line behind the appliance.
The water line lead-through is at
the bottom right of the appliance.
HCB 1560/1561
Water line feed-in from
left or right above the
anti tipping bracket
30" Single
60" Side by Side
Water supply line
Use a braided style ice maker hose with 1/4" compression
end or a 1/4" OD copper line to connect the water supply
with the solenoid valve of the appliance.
This is not supplied with the appliance.
Fully Integrated
The supplied brass fitting must be used
to connect to the solenoid as the plastic
threads on the solenoid are metric.