Use and Care Guide
14
operaTion 
 = Temperature display mode
You can choose the unit of temperature for the dis-
playindegreesFahrenheitordegreesCelsius.
Note
The factory setting is degrees Fahrenheit.
How to change the temperature display to 
degrees Celsius
• ActivatethesetupmodebytouchingtheSuperfrost 
iconfor5seconds.
• Touchthefreezer compartment Down icon until 
appearsinthefreezertemperaturedisplay.
• TouchtheSuperfrost icon
  - the display shows 
• TouchtheSuperfrost icon again
- the temperature reading is now displayed in degree 
Celsius.
• Exitsetupmodebytouchingthefreezercompart-
ment On/Off icon.
Note
To change the temperature display back to degrees 
Fahrenheit, follow the steps above. 
 = WaterquantityforIcecubetray
IftheproducedicecubesoftheIceMakeraretoo
small,theinflowingwaterquantitycanbeadjusted.
Howtoadjustthewaterquantity
• ActivatethesetupmodebytouchingtheSuperfrost 
iconfor5seconds.
• Touch the freezer compartment Down icon until 
appearsinthefreezertemperaturedisplay.
• TouchtheSuperfrost icon
- the display shows 
• Touchfreezer compartment Up icon 
  once only so 
E 4 appears in the display.
IMPORTANT
Do not increase for more than one step. If the 
adjusted value is too high the ice cube tray of the 
Ice Maker could overflow.
• TouchtheSuperfrost icon again.
• Exitsetupmodebytouchingthefreezercompart-
ment On/Off icon.
Checktheicecubesizewithinthenextdays.Ifthe
ice cubes are still smaller as desired, follow the steps 
above again.
Setup Mode - Figure 10
 = Display brightness
How to adjust the display brightness
• ActivatethesetupmodebytouchingtheSuperfrost 
iconfor5seconds.
• Touch the freezer compartment Down icon until 
appearsinthefreezertemperaturedisplay.
• TouchtheSuperfrost icon
- the display shows 
• Touchfreezer compartment 
 Up/Down icons to select
 0 = minimum to
   5 = maximum brightness 
• TouchtheSuperfrost icon at the desired value.
• Exitsetupmodebytouchingthefreezercompart-
ment On/Off icon.










