Side-by-Side Installation

7
Adhere the cover strips
leaving a gap of 1/4" to
each securing plate to
prevent interference when
installing the covers.
note
Step 11 is for HC (fully integrated) appli-
ances only.
11. Apply cover strips above, between and
below the securing plates on the left
side wall of the left appliance and on the
right side wall of the right appliance.
Cut the cover strips to the length as
shown in Step 11 using a pair of heavy
duty scissors or a utility knife.
11.
11.
12. Move the left appliance in front of the recess.
Move the power supply line to the area of the
electrical outlet.
WARNING!
Do not connect to the electrical outlet
before the installation is completed
and the water line is connected to the
solenoid valve.
Insert the water supply line for the ice maker
into its intended opening on the appliance
rear.
Refer to chapter
Connection to the water supply
in the installation instructions.
Slide the appliance into the recess or against
the back wall with freestanding applications.
Be sure the appliance castors runs in the
intended rail of the guide plate.
Install the right appliance in the same way.
12.