Side-by-Side Installation

6
9.
9.
Connect the cable of the heating blanekt with the
socket in the compressor compartment.
important
Make sure, that the heater cable is not laying on the
floor. Please put the cable inside the compressor
compartment.
10.
10. Open the doors and remove both covers.
8.
Bend the lower tongue of the heating
blanekt around the corner and adhere
to the back of the appliance.
8.
note
Heating blanket only has 17 W, so no
heat can be felt after installation.
important
After the cable of the heating blanket is connected,
insert the cable into the pre-installed cable holder.