Side-by-Side Installation

4
1.
Remove the protective foil from the
outside of both appliances (CS 2060,
CS 2061, CS 2080, CS 2081 only).
note
This installation instruction is applicable for CS
(freestanding) and HC (fully integrated) appliances.
Drawings assume placement of appliances in
cabinetry. There are no seperate drawings for free-
standing applications.
2.
Mount the anti tipping brackets for both
appliances.
Refer to chapter
Mounting the anti tipping device
in the installation instructions.
3.
Remove the protective foil of the double-
sided adhesive strips on the bottom of
the guide plate. The guide plate is sup-
plied with the SBS kit.
4.
Adhere the guide plate on the floor. The
rear edge of the plate must have contact
with the anti tipping brackets. Mark a
center line on the floor as illustrated and
align the notches of the guide plate with
this line.
NOTE
The guide plate may also be fastened with
screws through any hole wherever. The
screws are not provided with the appliance
or the kit.
2.
2.
3.
4.
important
The water supply lines for both appliances must be
located already in their correct positions as shown
in chapter „Cabinet opening dimensions“ in the
installation instructions or design guide.
important
Make sure, that the floor is clean (dust and
grease free), for the adhesive tape.
Side by Side (SBS) Installation
This kit may only be installed with models
CS 2061, CS 2081, HC 2061, HC 2081
HCB 2061, HCB 2081
CAUTION!
The Side by Side installation should only be done by
a trained expert. We recommend this procedure be
done by two people.
WARNING!
Electrocution hazard.
The refrigerator must be disconnected
from the source of electrical supply
before attempting the installation.
WARNING!
Risk of fire or damage.
The accessory is intended for use only
with a refrigerator that is marked to
indicate such use.