DesignGuide_freestanding_semi built in 30,36, and 60 inch

Freestanding/Semi Built In Models
The position of the electrical outlet can be within
the grey shaded areas or above the appliance.
Cabinet Opening Dimensions 36" Models
8
IMPORTANT
With 24" depth cabinets, the water line opening must be in
the location as shown as there will not be room to route a
water line behind the appliance for risk of pinching.
Also, for this cabinet depth the electrical outlet cannot be
behind the unit or the unit will not be able to be pushed all
the way back into the opening.
With cabinets deeper than 24" there is room to fit the
pipe behind the appliance and the wall so there are no
requirements for the water line lead out position.
Water line opening
Water supply line
Free length at least
31 - 1/2" (800 mm)
The cabinet opening height is 84" when using the
decorative grille. The decorative grille is deliver-
able as accessory and is not required for proper
operation of the appliance. All ventilation require-
ments are handled through the toe kick grille on
the appliance and this decorative grille is intended
to be used as a filler for pre-existing 84" openings.
See chapter "Accessories for Liebherr
Freestanding - Semi Built In Appliances"
page 15.
NOTE
The decorative upper grille attaches to the
cabinets / gables on either side of it and not to the
appliance itself nor any cabinet above.
The appliance can be used freestanding or semi built-in.
If semi built-in, consider the cabinet opening dimensions specified below.
Minimum opening height for the single door 36" models (CS 2060 / CS 2061) is 80".
Minimum opening height for the french door 36" models (CS 2062 / CBS 2062) is 80-1/2" to accommodate the top
mounted hinges.
The requirements for water supply and electrical outlet are the same for both applications.
IMPORTANT
Do not install the shut-
off valve for the water
supply behind the
appliance.