Use and Care

u Unscrew soft stop unit (2 x Torx® 15) Fig. 6 (7) .
u Slightly pull out soft stop unit, push it towards the
handle side and open it out.
u Set soft stop unit to the side.
u Unscrew bearing part
Fig. 6 (8) , turn it 180° and
move it to the opposite
side. Make preliminary
holes (optional) or use a
cordless screwdriver.
Fig. 8
4.3.2 Removing the upper door
Note
u To prevent food items from falling out, take all food out
of the door racks before removing the door.
Fig. 9
u Close upper door.
u Pull cover Fig. 9 (10) forward and upwards to remove.
u Lift off cover
Fig. 9 (11) .
CAUTION
Risk of injury if the door tips out!
u Keep a steady grip on the door.
u Set the door down carefully.
u Unscrew upper bearing bracket Fig. 9 (12) (2 x Torx® 25)
Fig. 9 (13) and pull it upwards to remove.
u Lift the upper door up and off and set it to the side.
4.3.3 Remove lower soft stop damper
Fig. 10
u Open the lower door.
NOTICE
Risk of damage!
If the door seal is damaged the door may not close prop-
erly and the level of cooling is insufficient.
u Do not damage the door seal with the screwdriver!
u Release panel Fig. 10 (20) using a slotted screwdriver
and remove.
w
The panel hangs above the damper bracket
Fig. 11
u Push panel forward over the damper bracket
Fig. 11 (24) in the direction of the appliance.
u Engage locking device
Fig. 11 (22) into place inside
oblong hole.
w
The locking device prevents the hinge from snapping
shut
u Lift off cover Fig. 11 (21) from the outside using a screw-
driver and remove by pulling outwards.
u Tip the appliance rearwards with the help of a second
person if needed.
u Push bolt Fig. 11 (23) out from below.
u Press damper bracket
Fig. 11 (24) in the direction of the
door.
u Remove panel Fig. 11 (20) .
u Unscrew entire soft stop unit (2 x Torx® 15) Fig. 11 (25) .
u Slightly pull out soft stop unit, push it towards the
handle side and open it out
u Set soft stop unit to the side
4.3.4 Removing the lower door
u Close the lower door.
Start-up
8 * Depending on model and options