Use and Care Manual

q
Another person to help with the installation, if neces-
sary
q
SW2 Allen key (supplied)
4.3.1 Remove upper soft stop damper
Fig. 4
u
Open upper door.
NOTICE
Risk of damage!
If the door seal is damaged the door may not close prop-
erly and the level of cooling is insufficient.
u
Do not damage the door seal with the screwdriver!
u
Release panel
Fig. 4 (1) using a slotted screwdriver and
remove.
w
The panel hangs above the damper bracket.
Fig. 5
u
Push panel forward over the damper bracket Fig. 5 (4) in
the direction of the appliance.
u
Engage locking device Fig. 5 (2) into place inside
oblong hole.
w
The locking device prevents the hinge from snapping
shut.
u
Unscrew cover Fig. 5 (5) that is on the hinge side until
the first notch using a screwdriver.
w
The bolt will become visible.
u
Push bolt Fig. 5 (3) out from below.
u
Press damper bracket Fig. 5 (4) in the direction of the
door.
u
Completely loosen cover Fig. 5 (5) that is on the hinge
side and remove.
u
Remove panel Fig. 5 (1) .
u
Loosen cover that is on the
hinge side Fig. 6 (6) using a
screwdriver and remove by
pulling outwards.
Fig. 6
u
Unscrew soft stop unit (2 x Torx® 15) Fig. 5 (7) .
u
Slightly pull out soft stop unit, push it towards the
handle side and open it out.
u
Set soft stop unit to the side.
u
Unscrew bearing part
Fig. 5 (8) , turn it 180° and
move it to the opposite
side. Make preliminary
holes (optional) or use a
cordless screwdriver.
Fig. 7
4.3.2
Removing the upper door
Note
u
To prevent food items from falling out, take all food out
of the door racks before removing the door.
Fig. 8
u
Close upper door.
u
Pull cover Fig. 8 (10) forward and upwards to remove.
u
Lift off cover Fig. 8 (11) .
CAUTION
Risk of injury if the door tips out!
u
Keep a steady grip on the door.
u
Set the door down carefully.
u
Unscrew upper bearing bracket Fig. 8 (12) (2 x Torx®
25) Fig. 8 (13) and pull it upwards to remove.
u
Lift the upper door up and off and set it to the side.
Start-up
7