Use and Care Manual
Table Of Contents
- 1The appliance at a glance
- 2General safety information
- 3Controls and displays
- 4Start-up
- 4.1Transporting the appliance
- 4.2Setting up the appliance
- 4.3Changing the door hinges
- 4.3.1Remove upper soft stop damper
- 4.3.2Removing the upper door
- 4.3.3Remove lower soft stop damper
- 4.3.4Removing the lower door
- 4.3.5To swap over central bearing parts
- 4.3.6To swap over lower bearing parts
- 4.3.7Swapping the handles
- 4.3.8Fitting the lower door
- 4.3.9Fitting the lower soft stop damper
- 4.3.10Fitting the upper door
- 4.3.11Fitting the upper soft stop damper
- 4.3.12Aligning the doors
- 4.4Side-by-side installation
- 4.5Water connection
- 4.6Installation into a fitted kitchen
- 4.7Anti-tip device
- 4.8Installing the water filter*
- 4.9Disposal of packaging
- 4.10Connecting the appliance
- 4.11Switching on the appliance
- 5Operation
- 6Maintenance
- 7Troubleshooting
- 8Putting appliance out of service
- 9Disposing of the appliance
- 10Liebherr Warranty Plan
- 1Vue d'ensemble de l'appareil
- 2Consignes de sécurité générales
- 3Eléments de commande et d'affichage
- 4Mise en service
- 4.1Transport de l'appareil
- 4.2Mise en place de l'appareil
- 4.3Inverser le sens de butée de porte
- 4.3.1Enlever l'amortisseur de fermeture supérieur
- 4.3.2Enlever la porte du haut
- 4.3.3Enlever l'amortisseur de fermeture inférieur
- 4.3.4Enlever la porte inférieure
- 4.3.5Inverser les éléments pivotants du milieu
- 4.3.6Inverser les éléments pivotants inférieurs
- 4.3.7Inverser les poignées
- 4.3.8Assembler la porte du bas
- 4.3.9Monter l'amortisseur de fermeture inférieur
- 4.3.10Assembler la porte du haut
- 4.3.11Monter l'amortisseur de fermeture supérieur
- 4.3.12Mettre les portes à niveau
- 4.4Montage du combiné Side-by-Side
- 4.5Prise d'eau
- 4.6Insertion entre deux éléments de cuisine
- 4.7Sécurité anti-basculement
- 4.8Installer le filtre à eau*
- 4.9Eliminer l'emballage
- 4.10Brancher l'appareil
- 4.11Enclencher l'appareil
- 5Commande
- 6Entretien
- 7Dysfonctionnements
- 8Mise hors service
- 9Elimination de l'appareil
- 10GARANTIE Liebherr
- 1Visión general del aparato
- 2Notas generales sobre seguridad
- 3Componentes de uso e indicación
- 4Puesta en marcha
- 4.1Transporte del aparato
- 4.2Instalación del aparato
- 4.3Cambio del tope de puerta
- 4.3.1Retirar el amortiguador de cierre superior
- 4.3.2Retirar la puerta superior
- 4.3.3Retirar el amortiguador de cierre inferior
- 4.3.4Retirar la puerta inferior
- 4.3.5Cambiar de sitio las piezas de cojinete intermedias
- 4.3.6Cambiar de sitio las piezas de cojinete inferiores
- 4.3.7Cambiar de sitio los tiradores
- 4.3.8Montar la puerta inferior
- 4.3.9Montar el amortiguador de cierre inferior
- 4.3.10Montar la puerta superior
- 4.3.11Montar el amortiguador de cierre superior
- 4.3.12Alinear las puertas
- 4.4Montaje Side-by-Side
- 4.5Conexión de agua
- 4.6Inserción en el mueble de la cocina
- 4.7Seguro antivuelco
- 4.8Colocación del filtro de agua*
- 4.9Eliminación del embalaje
- 4.10Conexión del aparato
- 4.11Activación del aparato
- 5Uso
- 6Mantenimiento
- 7Averías
- 8Puesta fuera de servicio
- 9Eliminación del aparato
- 10PLAN DE GARANTÍA Liebherr
Problem Possible Cause Correction
activated, fresh food has just been
placed in the appliance or the door
has been left open for a while.
The ambient temperature is too high.
u
Solution: (see 1.3)
A low hum
The sound occurs as a result of fan
air flow.
u
The sound is normal.
Vibration noise
The appliance is not standing firmly
on the floor As a result, adjoining
units or objects are set into vibration
by the running refrigeration unit
u
Align the appliance using the adjustable feet
u
Move bottles and containers apart.
The temperature
display indi-
cates: F0 to F9.
There is a fault.
u
Contact the customer service department. (see
Maintenance).
The temperature
display reads:
FE*
There is a fault.
u
Contact the customer service department. (see
Maintenance).
The temperature
display indicates
power failure
. The
warmest temper-
ature reached
during the
power failure is
displayed in the
temperature
display.
The freezer temperature rose too
high during the last hours or days
due to power failure or power inter-
ruption. When the power interruption
is over, the appliance will continue to
operate at the last temperature
setting.
u
To delete the display of the warmest temperature:
Press the Alarm button
Fig. 3 (15)
.
u
Check the quality of the food. Do not consume
spoiled food. Do not re-freeze defrosted food.
DEMO lights up
in the tempera-
ture display.
The demo mode is activated.
u
Contact the customer service department. (see
Maintenance).
The outside
surfaces of the
appliance are
warm.
The heat of the refrigerant circuit is
used to prevent condensate from
forming.
u
This is normal.
The IceMaker
cannot be
switched on.*
The appliance and therefore the
IceMaker are not connected.
u
Connect the appliance (see Start-up).
The IceMaker is
not making ice
cubes.*
The IceMaker is not switched on.
u
Switch the IceMaker on.
The drawer of the IceMaker is not
properly closed.
u
Close the drawer properly.
The water connection is not open.
u
Open the water connection.
The waterline was not bled of all air
during installation
u
Please contact your qualified installation plumber to
ensure the above criteria is met before calling for
service.
The door of the appliance is not
closed properly.
u
Close the appliance door.
Troubleshooting
27