Use and Care Manual

u
Connect the combination unit to the power supply
(see 4.10) .
Appliances with IceMaker:
u
Connect the appliance to the water supply (see 4.5) .
All appliances
u
Fit the anti-tip device (see 4.7) .
NOTICE
Moving the SBS combination may result in damage!
The assembled SBS combination is heavy. If not moved
properly, the appliance may become dented.
u
Read and follow the moving tips (see above).
u
Carefully push the combination into the designated
position.
u
Align the combination again if necessary using the
adjustment feet.
u
Lower thecentre adjustment feet
Fig. 21 (C) again until
they touch the floor.
u
Then shore up the door: Lower theadjutment feet
Fig. 21 (A) onto the bearing bracket until they contact
the floor then turn 90° again.
The door height can be
adjusted at the lower outside
bearing brackets:
u
Unscrew the threaded pin
Fig. 29 (17) a little (no more
than one turn).
Fig. 29
Fig. 30
u
To lift the door unscrew the bearing pin Fig. 30 (18)
clockwise using the supplied open-end wrench
Fig. 30 (11) . The appliance is delivered from the factory
with the bearing pin screwed in completely.
u
Screw the threaded pin Fig. 29 (17) in again to fix the
bearing pin.
4.5 Water connection
WARNING
Electrical Shock Hazard!
u
Do not make the water connection while the appliance
is connected to an electrical outlet.
u
Disconnect the water supply before connecting the
water lines for the IceMaker.
u
The connection to the water supply may only be made
by a trained and licensed plumber.
WARNING
Poisoning Hazard!
u
The water quality must comply with the drinking water
regulations for the geographical area where the appli-
ance is located.
u
The IceMaker is designed exclusively to make ice
cubes in quantities needed by a household and must
only be operated with water appropriate for this
purpose.
Water pressure:
psi MPa (bars)
21.76 to 87.02 0.15 to 0.6 (1.5 to 6)
- Water must be supplied to the appliance through a cold
water pipe that complies with hygiene standards and
can withstand the operating pressure.
- All devices and equipment used to supply water must
comply with the regulations in force in the respective
country.
- The solenoid valve is located at the bottom of the back
of the appliance. It has a metric R3/4 connecting
thread.
Fig. 31
u
Remove the cap Fig. 31 (1) from the solenoid valve
Fig. 31 (2) .
u
Ensure that the gasket Fig. 31 (3) is inserted in the
elbow connection Fig. 31 (4) supplied.
u
Connect the elbow adapter Fig. 31 (4) to the solenoid
valve Fig. 31 (2) and tighten with an open-ended
wrench, for example.
NOTICE
Risk of thread damage!
u
Do not overtighten.
u
Connect the domestic water supply
Fig. 31 (5) (e.g.
copper pipe) to the elbow connector Fig. 31 (4) .
Before fitting into the cabinet:
u
Check the whole water system for leaks.
Before using for the first time:
u
Have the water line bled (remove air) by a competent
professional.
Start-up
13