Use and Care Manual

u
Remove plastic cap
Fig. 12 (33) .
CAUTION
Risk of injury if the door tips out!
u
Keep a steady grip on the door.
u
Set the door down carefully.
u
Open the lower door.
u
Unscrew center bearing bracket Fig. 12 (31) (2 x Torx®
25).
u
Lift lower door upwards to remove and set it to the side
4.3.5 To swap over central bearing parts
Fig. 12
u
Carefully remove cover trim Fig. 12 (30) .
u
Turn the center bearing bracket Fig. 12 (31) and washer
Fig. 12 (35) 180° and secure tightly (to 4 Nm) on the
new hinge side.
u
Turn the cover trim Fig. 12 (30) 180° and snap it back
into place on the new handle side.
4.3.6 To swap over lower bearing parts
Fig. 13
u
Unscrew grub screw Fig. 13 (60) by approx. 1 turn using
the socket wrench supplied.
u
Unscrew the bearing pin
Fig. 13 (42) , with disc
Fig. 13 (43) and positioning foot Fig. 13 (44) , in an
upwards direction.
u
Lift off plug Fig. 13 (41) .
u
Unscrew Fig. 13 (46) bearing bracket Fig. 13 (45) .
u
Completely unscrew the grub screw Fig. 13 (60) and
screw it into the opposite side of the bearing bracket
until it is externally flush with the bearing bracket.
u
Unscrew bearing part Fig. 13 (48) , turn it 180° and
tighten Fig. 13 (49) it to the inside.
u
Insert plug Fig. 13 (41) back into the other hole.
u
Carefully lift off the cover on the handle side Fig. 13 (47)
and move it to the opposite side.
u
Using a cordless screwdriver if necessary, again
secure the bearing bracket Fig. 13 (45) on the new hinge
side tightly (to 4 Nm).
u
Screw complete bearing pin Fig. 13 (42) , with disc and
positioning foot, back into place again.
u
Tighten grub screw Fig. 13 (60) .
4.3.7 Swapping the handles
For both the upper and lower door:
Fig. 14
u
Pull plugs Fig. 14 (50) out of the door bearing bushes
and move them to the other side.
u
Detach the door handle Fig. 14 (52) , plug Fig. 14 (53) and
pressure plates* Fig. 14 (54) and move them to the
opposite side.
u
When fitting the pressure plates on the opposite side,
make sure they engage correctly.*
4.3.8 Fitting the lower door
u
Position the lower door from above onto the lower
bearing pins
Fig. 13 (42) .
u
Close the door.
u
Place the plastic cap Fig. 12 (33) back onto the center
bearing bracket Fig. 12 (31) .
u
Insert the center bearing pin Fig. 12 (32) on the new
hinge side through the center bearing bracket
Fig. 12 (31) into the lower door.
u
Place disc Fig. 12 (34) onto the center bearing pin
Fig. 12 (32) .
Start-up
* Depending on model and options 9