Use and Care Manual

Fig. 50
To install a new water filter:
u
Insert the water filter Fig. 50 (3) and turn it approximately
100° clockwise until it locks into position.
u
Slide the tray Fig. 50 (1) in.
u
Place the cover Fig. 50 (2) on the filter.
u
Write the date of the next filter replacement on the
supplied adhesive label Fig. 50 (4) and affix it to the
module.
Note
New water filters may contain particulate matter.
u
Do not consume or use ice cubes produced within 72
hours after replacing the filter.
u
Remove any ice still present in the IceMaker tray. You
can keep this ice in another tray for later use.
u
Make sure the filter is leak-tight and no water is coming
out.
6.2 Defrosting with NoFrost
The NoFrost system defrosts the appliance automatically.
Fridge compartment:
The defrosted water is evaporated by the heat of the
compressor. Drops of water on the back wall are a func-
tional feature and completely normal.
u
Clean the drain opening regularly so that the defrosted
water can flow away (see 6.3) .
Freezer compartment:
The moisture condenses on the evaporator and is periodi-
cally defrosted and evaporated.
u
The appliance does not need to be defrosted manually.
6.3 Cleaning the appliance
WARNING
Danger of electric shock.
u
Unplug refrigerator or disconnect power.
WARNING
Risk of injury or damage due to hot steam.
Hot steam can cause scalding/burns and damage to
surfaces.
u
Do not use steam cleaners.
NOTICE
Incorrect cleaning damages the appliance.
u
Do not use concentrated cleaning agents.
u
Do not use steel wool or sponges that scour or scratch.
u
Do not use caustic or abrasive cleaning materials or
those containing sand, chloride, chemicals or acids.
u
Do not use chemical solvents.
u
Do not damage or remove the rating plate on the inside
of the appliance. It is vital for the customer service
department.
u
Do not pull off, kink or damage any cables or other
components.
u
Do not let cleaning water get into the drain gutter, the
ventilation grille and electrical parts.
u
Use soft cleaning cloths and a multi-purpose cleaning
agent with a neutral pH value.
u
Only use food-compatible cleaning and care agents
inside the appliance.
u
Empty the appliance.
u
Disconnect the power plug.
u
Clean the plastic surfaces, outside and inside, by
hand using lukewarm water and a little dish washing
liquid.
Stainless steel which is exposed to chlorine gas or damp-
ness may become discolored. This is normal. If your
appliance is exposed to chlorine gas or dampness, clean
and polish it more frequently. If there are any signs of rust
or discoloration, clean and polish the appliance as soon
as possible.
Do not apply stainless steel cleaning agents to glass or
plastic surfaces so as not to scratch them. Initially darker
areas and quite an intensive color of the stainless steel
surfaces are normal.
NOTICE
The stainless steel doors are treated with a high-grade
surface coating and must not be cleaned with the
supplied cleaning agent.
This would damage the surface coating.
u
Wipe the coated door surfaces using a soft, clean
cloth only. In case of stubborn dirt, use a little water or a
neutral cleaning agent. A microfibre cloth can be
optionally used.
u
If the stainless steel side walls are dirty, clean them
using a commercially available stainless steel cleaning
agent. Then evenly apply the accompanying stainless
steel care product, making strokes in the direction of
the grain.
u
Wipe side walls with a paint finish using a soft, clean
cloth only. In case of stubborn dirt, use a little water or a
neutral cleaning agent. A microfibre cloth can be
optionally used.
Maintenance
* Depending on model and options 25