Use and Care Manual

5.7.5 Shelves
Shifting or removing shelves
CAUTION
Danger of lacerations!
The storage shelf can shatter if dropped or mishandled.
You could cut yourself on the pieces of broken glass.
u
Only remove storage shelves when there is nothing on
them.
Extension stops secure the shelves against being acci-
dentally pulled out.
Fig. 42
u
Lift up the shelf and pull it slightly forward.
u
Adjust the shelf height by shifting the spacers in the
runners.
u
Insert the short shelf at the height of the gallon capacity
rack so that door closes properly. It is supported on
support bars.
u
To remove the shelf completely, set it at an angle and
pull it out towards you.
u
Insert the shelf with the raised edge to the back
pointing upwards.
w
This prevents food from contacting and freezing to the
back wall.
The bottle holder offers additional storage for bottles
(maximum height 11-13/16 '' (300 mm)). It fits onto the
same supports as the other racks.
u
Insert the bottle holder into any position, but not right at
the bottom.
To dismantle shelves
u
The shelves can be
dismantled for cleaning.
5.7.6 Using the split shelf
CAUTION
Danger of lacerations!
The storage shelf can shatter if dropped or mishandled.
You could cut yourself on the pieces of broken glass.
u
Only remove storage shelves when there is nothing on
them.
Fig. 43
u
Attach support bars supplied, ensuring right (R) and left
(L) parts are correctly positioned.
u
The glass shelf with stop face (2) has to be at the back.
5.7.7 Door racks
Note
u
Do not load the door with more than 40 lbs (18 kg) of
food.
Repositioning the door racks
u
Push rack up, pull forward, and reinsert in the reverse
order.
The container trays can be
removed and placed on the
table as a unit.
Instead of one wide container and one small container, a
special set containing three small containers is available
from Customer Service.
It is possible to use one or both boxes. If unusually tall
bottles are to be stored, only suspend one box above the
bottle rack.
u
To swap containers: pull
up to remove and reinsert
in the desired position.
Operation
* Depending on model and options 21