Use and Care Manual

The appliance can be built into the range of kitchen units.
To bring the appliance Fig. 33 (2) up to the height of the
fitted kitchen units, a suitable top cupboard Fig. 33 (1) can
be added above the appliance.
When converting kitchen cabinets (max. depth 22-5/16 "
(580 mm)) the device can be set up directly beside the
kitchen cabinet Fig. 33 (3) . The appliance door projects
(34 mm) at the side and in the center of the appliance
(50 mm) from the front of the kitchen cabinet. This allows
it to open and close properly.
Ventilation requirements:
-
There must be a ventilation shaft at least 2 " (51 mm)
deep at the back of the top cupboard over the entire
width of the top cupboard.
-
The cross section of the ventilation gap below the
ceiling must be at least 46.5 in
2
(300 cm
2
).
-
The bigger the ventilation gap, the more energy-saving
the operation of the appliance.
If the appliance is installed with the hinges next to a wall
Fig. 33 (4) , the gap between the appliance and the wall
must be at least 1-9/16 '' (40 mm). This is how far the
handle protrudes when the door is open.
4.7 Anti-tip device
The screws for fastening the anti-tip device are not
supplied with the appliance. Appropriate screws must be
used for the material (wood, concrete, etc.) in which the
safety device is mounted.
WARNING
Risk of injury if the appliance tips over!
u
Install the anti-tip device to prevent the appliance from
tipping over when the fully loaded door is open.
NOTICE
Risk of damage due to leaking water!
If the tilt safety device has been fitted in another position
than the one given, the water hoses may be damage
when pushing the appliance into the niche.
u
Only fit the tilt safety device in the position shown in the
diagram.
Fig. 34
u
Mark the installation position for the anti-tip device on
the wall or back of the unit.
u
Install the anti-tip device Fig. 34 (1) using appropriate
screws Fig. 34 (2) .
4.8 Installing the water filter*
The water filter ensures optimum water
quality and is available as an accessory. It
should be installed near the appliance in
the cabinet, for example in the adapter
cabinet above the appliance. To connect
the filter to the appliance, it may be
necessary to make an opening (C) in the
floor of the adapter cabinet through which
the hoses will be routed. Depending on
your installation setup, you can route the
two water filter hoses either through the
rear panel or through the base of the
cabinet. The maximum length of the water
hose is118-1/8 '' (3 m).
Alternatively, the appliance can also be
operated without the water filter.
Fig. 35
(A) 13/16 in (20mm) (C) 1-3/16in. x 3/8in.
( 30mm x 10mm )
(B) 3-15/16 in (100mm) (D) min. 4 in (100mm)
Start-up
* Depending on model and options 15