Use and Care Manual

Fig. 9
u
Close upper door.
u
Pull cover
Fig. 9 (10) forward and upwards to remove.
u
Lift off cover Fig. 9 (11) .
CAUTION
Risk of injury if the door tips out!
u
Keep a steady grip on the door.
u
Set the door down carefully.
u
Unscrew upper bearing bracket Fig. 9 (12) (2 x Torx®
25) Fig. 9 (13) and pull it upwards to remove.
u
Lift the upper door up and off and set it to the side.
4.3.3 Remove lower soft stop damper
Fig. 10
u
Open the lower door.
NOTICE
Risk of damage!
If the door seal is damaged the door may not close prop-
erly and the level of cooling is insufficient.
u
Do not damage the door seal with the screwdriver!
u
Release panel
Fig. 10 (20) using a slotted screwdriver
and remove.
w
The panel hangs above the damper bracket
Fig. 11
u
Push panel forward over the damper bracket
Fig. 11 (24) in the direction of the appliance.
u
Engage locking device Fig. 11 (22) into place inside
oblong hole.
w
The locking device prevents the hinge from snapping
shut
u
Lift off cover Fig. 11 (21) from the outside using a screw-
driver and remove by pulling outwards.
u
Tip the appliance rearwards with the help of a second
person if needed.
u
Push bolt Fig. 11 (23) out from below.
u
Press damper bracket
Fig. 11 (24) in the direction of the
door.
u
Remove panel Fig. 11 (20) .
u
Unscrew entire soft stop unit (2 x Torx® 15) Fig. 11 (25) .
u
Slightly pull out soft stop unit, push it towards the
handle side and open it out
u
Set soft stop unit to the side
4.3.4 Removing the lower door
u
Close the lower door.
u
Pull center bearing pin Fig. 12 (32) and disc Fig. 12 (34)
out of the bearing bracket and the lower door.
u
Remove plastic cap Fig. 12 (33) .
CAUTION
Risk of injury if the door tips out!
u
Keep a steady grip on the door.
u
Set the door down carefully.
u
Open the lower door.
u
Unscrew center bearing bracket Fig. 12 (31) (2 x Torx®
25).
u
Lift lower door upwards to remove and set it to the side
Start-up
8 * Depending on model and options