Use and Care Manual

u
Align the appliance so that it
stands firmly and on a level
by applying the accompa-
nying spanner to the adjust-
able-height feet (A) and
using a spirit level.
u
Then support the door:
Extend the adjustable foot
at the turn hinge (B) until it
rests on the floor and then
make a further 90° turn.
Note
u
Clean the appliance (see 6.3) .
If the appliance is set up in humid areas, condensation
may build on the outside of the appliance.
u
Always ensure proper ventilation.
4.3 Changing the door hinges
You can reverse the door hinges, if necessary:
Make sure you have the following tools on hand:
q
Torx® 25
q
Torx® 15
q
Screwdriver
q
Cordless screwdriver, if necessary
q
Another person to help with the installation, if neces-
sary
q
SW2 Allen key (supplied)
4.3.1 Remove upper soft stop damper
Fig. 5
u
Open upper door.
NOTICE
Risk of damage!
If the door seal is damaged the door may not close prop-
erly and the level of cooling is insufficient.
u
Do not damage the door seal with the screwdriver!
u
Release panel Fig. 5 (1) using a slotted screwdriver and
remove.
w
The panel hangs above the damper bracket.
Fig. 6
u
Push panel forward over the damper bracket
Fig. 6 (4) in
the direction of the appliance.
u
Engage locking device Fig. 6 (2) into place inside
oblong hole.
w
The locking device prevents the hinge from snapping
shut.
u
Unscrew cover Fig. 6 (5) that is on the hinge side until
the first notch using a screwdriver.
w
The bolt will become visible.
u
Push bolt Fig. 6 (3) out from below.
u
Press damper bracket Fig. 6 (4) in the direction of the
door.
u
Completely loosen cover Fig. 6 (5) that is on the hinge
side and remove.
u
Remove panel Fig. 6 (1) .
u
Loosen cover that is on the
hinge side
Fig. 7 (6) using a
screwdriver and remove by
pulling outwards.
Fig. 7
u
Unscrew soft stop unit (2 x Torx® 15) Fig. 6 (7) .
u
Slightly pull out soft stop unit, push it towards the
handle side and open it out.
u
Set soft stop unit to the side.
u
Unscrew bearing part
Fig. 6 (8) , turn it 180° and
move it to the opposite
side. Make preliminary
holes (optional) or use a
cordless screwdriver.
Fig. 8
4.3.2 Removing the upper door
Note
u
To prevent food items from falling out, take all food out
of the door racks before removing the door.
Start-up
* Depending on model and options 7