Use and Care Manual

u
Tighten the centre adjustment feet
Fig. 22 (C) so that
there is no floor contact.
u
Align the combination with the outer adjustment feet
Fig. 22 (B) .
Fig. 27
Before inserting the trim Fig. 27 (12) squeeze the two fillets
together along the entire length. The trim can now be
inserted more easily into the gap. When pressing in the
trim, use a soft cloth to prevent dents on the surface of the
trim. Press the trim carefully and evenly into the gap to
achieve the best possible fit.
u
On the front press the long trim Fig. 27 (12) into the
vertical gap. Ensure that the trim rests on the
connecting panel Fig. 27 (5) .
u
Remove protective film from the trim.*
Fig. 28
u
On the top, press the short trim Fig. 28 (13) into the gap.
The trim must form a flush finish with the connecting
plate Fig. 28 (3) on the front edge.
u
Snap the cover Fig. 28 (14) onto the open space
between the two control panel trims. Make sure that the
outer surfaces of the cover form a flush finish with the
control panel trims. The cover can be extended for this
purpose.
Fig. 29
u
Position the lower cover
Fig. 29 (15) from above onto the
connecting panel Fig. 29 (5) and snap it down into place.
u
Connect the combination unit to the power supply
(see 4.10) .
Appliances with IceMaker:
u
Connect the appliance to the water supply (see 4.5) .
All appliances
u
Fit the anti-tip device (see 4.7) .
NOTICE
Moving the SBS combination may result in damage!
The assembled SBS combination is heavy. If not moved
properly, the appliance may become dented.
u
Read and follow the moving tips (see above).
u
Carefully push the combination into the designated
position.
u
Align the combination again if necessary using the
adjustment feet.
u
Lower thecentre adjustment feet Fig. 22 (C) again until
they touch the floor.
u
Then shore up the door: Lower theadjutment feet
Fig. 22 (A) onto the bearing bracket until they contact
the floor then turn 90° again.
The door height can be
adjusted at the lower outside
bearing brackets:
u
Unscrew the threaded pin
Fig. 30 (17) a little (no more
than one turn).
Fig. 30
Fig. 31
u
To lift the door unscrew the bearing pin Fig. 31 (18)
clockwise using the supplied open-end wrench
Fig. 31 (11) . The appliance is delivered from the factory
with the bearing pin screwed in completely.
u
Screw the threaded pin Fig. 30 (17) in again to fix the
bearing pin.
4.5 Water connection*
WARNING
Electrical Shock Hazard!
u
Do not make the water connection while the appliance
is connected to an electrical outlet.
u
Disconnect the water supply before connecting the
water lines for the IceMaker.
u
The connection to the water supply may only be made
by a trained and licensed plumber.
Start-up
* Depending on model and options 13