Use and Care Manual

The appliances are automatically aligned in depth with the
connecting sheet. If one appliance projects further
forward than the other start with this one. Otherwise start
with the left hand appliance.
u
Fix the connecting sheet Fig. 23 (5) loosely to one appli-
ance with two screws Fig. 23 (6) .
u
Move the connecting sheet to the side so that the
centre bar of the sheet is touching the side wall of the
appliance. Tighten the screws.
u
Screw the connecting sheet to the second appliance
too. If necessary push the appliances together or apart
a little.
Back of the appliance:
Fig. 24
u
Place the connecting clamps
Fig. 24 (8) at the top of the
centre side walls.
u
Insert theconnecting angle Fig. 24 (9) underneath into
the corresponding space.
u
If the connecting angle is somewhat loose, fit a screw
Fig. 24 (10) .
Note
u
To prevent vibration noise, the brackets and screws
must not come into contact with the clamps or the
screws on the pipework on the back.
Front of the appliance:
Fig. 25
NOTICE
Risk of damage to the castors.
u
Do not use a power tool to adjust the rear adjustment
feet as it will damage the leveling mechanism or disen-
gage the rod – instead use a hand ratchet.
The front adjustment feet can be adjusted with the
supplied open-end wrench Fig. 25 (11) and the rear adjust-
ment feet* with a 1/4'' bit attachment.
u
Tighten the centre adjustment feet
Fig. 21 (C) so that
there is no floor contact.
u
Align the combination with the outer adjustment feet
Fig. 21 (B) .
Fig. 26
Before inserting the trim Fig. 26 (12) squeeze the two fillets
together along the entire length. The trim can now be
inserted more easily into the gap. When pressing in the
trim, use a soft cloth to prevent dents on the surface of the
trim. Press the trim carefully and evenly into the gap to
achieve the best possible fit.
u
On the front press the long trim Fig. 26 (12) into the
vertical gap. Ensure that the trim rests on the
connecting panel Fig. 26 (5) .
u
Remove protective film from the trim.*
Fig. 27
u
On the top, press the short trim Fig. 27 (13) into the gap.
The trim must form a flush finish with the connecting
plate Fig. 27 (3) on the front edge.
u
Snap the cover Fig. 27 (14) onto the open space
between the two control panel trims. Make sure that the
outer surfaces of the cover form a flush finish with the
control panel trims. The cover can be extended for this
purpose.
Fig. 28
u
Position the lower cover
Fig. 28 (15) from above onto the
connecting panel Fig. 28 (5) and snap it down into place.
Start-up
12 * Depending on model and options