Use and Care Manual

11
operaTion
Temperature Display - Figure 8
Innormaloperation,thefollowingsettingswillbe
displayed:
• theaveragerefrigeratortemperature
• thewarmestfrozenfoodtemperature.
When starting up for the first time or when
the appliance is warm, dashes will appear
inthefreezertemperaturedisplay,untilthe
temperatureinthefreezercompartmentis
32°F(0°C).
Itwilltakebetweenthreeandeighthoursforthe
requiredtemperature,0°For38°F(-18°Cor3°C)to
be reached and displayed permanently in the display,
depending on the ambient conditions and the tempera-
ture setting.
The display will flash:
• ifyouchangethetemperatureor
• ifthetemperaturerisesbyseveraldegrees,indicating
coldloss,e.g.ifyouplacefresh,“warm”foodinthe
freezerorifyouremoveorrepackfrozenfood,the
temperature may rise for a short time due to warm air
flowingintothefreezer.
• If“F1” to “F5” appears in the display, the appliance
hasafault.Havethefaultnumberavailablewhenyou
contact the customer service department.
Audible Alarm Signal - Figure 8
Theaudiblealarmsignalhelpstoprotectfrozenfood
and to save energy.
The audible alarm signal is switched off by touching
the alarm icon.
Audible door alarm
This sounds when the door has been left open for lon-
gerthanabout180seconds.Thesoundswitch-offfunc-
tion is active as long as the door is left open. The alarm
automatically switches back to standby when the door
is shut.
Audible/visual temperature alarm
Italwayssoundsifthefreezertemperatureisnotlow
enough. The temperature display and the alarm LED
flashes at the same time.
Thiscanbecausedby:
- warm,freshfoodbeingplacedinthefreezer;
- too much warm air from the outside entering when re-
arrangingorremovingfrozenfood,
- a fault in the appliance.
The temperature display will continue to flash until the
causeofthealarmhasbeenrectified.Itwillthenstop
flashing and light up continually. The audible warning
signal is now automatically reset.
Power Failure/Frost-Control
Display - Figure 8
IfthepowerfailureLED islit,thismeansthefreezer
temperature has risen too high during the last few hours
ordaysduetoapowerfailure.Thefreezertemperature
display flashes at the same time.
• IfyoutouchtheAlarm icon now, the highest tem-
perature registered during the power failure will be
displayed.
• Checkthequalityofthefoodincaseithasbecome
too warm or even defrosted.
• Thehighesttemperaturewillappearforapproximately
oneminute.Afterthat,theactualtemperatureinthe
freezerwillreappear.
 ThedisplaycanbeturnedoffbytouchingtheAlarm
icon again.
Supercool - Figure 8
TouchingtheSupercooliconswitchestherefrigerator
compartmenttomaximumcooling.Itisrecommended
particularly if you wish to cool large quantities of food,
drinks, freshly baked goods or meals rapidly.
• Turning on:TouchtheSupercoolicon briefly so the
LED
turns on. The refrigerator temperature will
drop to its lowest value.
IMPORTANT
The Supercool function uses slightly more energy.
After approximately six hours, however, the refrig-
erator switches back automatically to normal ener-
gy-saving operation. If required, the Supercooling
function can be turned off sooner.
• Turning off:TouchtheSupercooliconagainuntilthe
LED
turns off.