Design Guide

Freestanding/Semi Built In Models
17
24" and 48" Models: CS 1311 / CS 1360, SBS 26S1, CS 1200, CS 1350B
Minimum Cabinet Opening Dimen-
sions:
(A) 47-3/4" (1212 mm)
(B) 24" (609 mm)
(C) 85-7/8" (2182 mm)
(D) CS 13.. 80" (2032 mm)*
CS 12.. 72-3/8" (1838 mm)*
Cabinet Opening Dimensions: SBS 26S1
3"
(76 mm)
The appliance can be integrated into
the kitchen units.
To adapt the appliance to the height
of the row of kitchen units, a suitable
top cupboard can be fitted above the
appliance.
Unit Venting
DO NOT restrict the air flow. A cross-
sectional air flow of at least 62" square
(400cm ²) must be provided. The
opening can either be directly over the
appliance or behind of the cabinet on
top of the unit (see ventilation require-
ments).
The SBS 26S1 model can be in-
stalled in standard 24" (609mm) deep
cabinets. You will only have to make
sure that the door swing clearance is
enough. It is possible to push the SBS
26S1 to the rear wall of the cabinet
without modification.
When installing the appliance next to
a wall, a distance on the hinge side of
1 13/32 inches (36 mm) minimum is
required between the appliance and
the wall to allow for the door handle
projection when the door is open.
*NOTE
The given cabinet opening height di-
mension is such that it accommodates
the ventilation requirements for the
appliance. If you will be bringing the
cabinet above or header of the open-
ing down tight (no air space - refer to
the section 'Top Door Hinge Clear-
ance' later in this Design Guide) to
the top of the appliance for a built-in
look then you still must accommodate
ventilation by some other means. The
warm air from behind the appliance
must be able to escape. Please refer
to the section 'Ventilation Require-
ments' further on in this Design Guide.