Quick Start Guide

Page 2
ADJUSTABLE RACK-MOUNT KIT INSTALLATION
4. Prepare the UPS or Battery Cabinet (the
"equipment") for rack mounting by following
instructions in the equipment's user manual. The
equipment may require additional parts to be added
or parts to be removed for rack mounting. After it is
prepared, lay equipment in rack-mounting position.
Fasten Inner Members from Step 1 to the
equipment on both sides as shown in Figure 4 with
(8) M4 Screws provided in this kit. Make sure
Retaining Latch is near the rear of the equipment
as shown (See Figure 4).
5. (CAUTION: LIFTING EQUIPMENT INTO RACK
MAY BE A TWO-PERSON JOB, DEPENDING ON
WEIGHT OF EQUIPMENT. SEE EQUIPMENT'S
USER MANUAL.) Insert the equipment, with Inner
Members attached from Step 4, into Bracket
Assemblies by inserting top and bottom edges of
Inner Members into the top and bottom, curved
tracks of Front Members and sliding the equipment
into Rack (See Figure 5A). Ends of Inner Members
are tapered to allow rear of the equipment to be
angled upward before insertion, if space allows.
Then the rear, bottom edges of Inner Members can
be placed into front edge of bottom tracks, and the
front of the equipment can be tipped up into
horizontal position to insert the top edges of Inner
Members before sliding the equipment into Rack
(See Figure 5B). The equipment should move
smoothly into Bracket Assemblies. If not, recheck
alignment of Front and Rear Members from Steps 2
and 3.
6. Secure front of the equipment to Rack Mounting
Rails to prevent the equipment from sliding out of
position. If securing holes are provided on front of
the equipment that align with the center holes on
return flange of Front Members, you can use the
extra (4) M5 Screws provided in this kit to secure
the equipment. Otherwise, the equipment should
be secured to front of Rack Mounting Rails with (4)
customer-supplied fasteners.
Part Number 202827 2/14 Rev. 1
Figure 4
Figure 5A
M4
SCREWS
M4
SCREWS
UPS OR
BATTERY
CABINET
RETAINING
LATCH
UPS OR
BATTERY
CABINET
FRONT
Figure 3B
M4
SCREWS
M4 NUTS
32" RACK
DEPTH
M4 NUTS
Figure 5B