User Manual

Log Screen
The Log Screen offers tabs that list the current alarms and the alarm/event history.
Table 4.4 below,
describes the alarm messages you may see in the logs.
To view the logs:
1. At the main menu, select the Log icon, and press Enter.
2. Use the arrow buttons to move the cursor left/right and select a tab, then press Enter to
display the log for the selected tab.
Figure 4.7 Current and History Log Tabs
MESSAGE DESCRIPTION
Aux. power fault The auxiliary power output voltage exceeds the normal range
Battery cabinet
connect
abnormal
An incorrect number of externalbattery cabinets are connected to the UPS.
Battery EOD Battery end of discharge.
Battery low
pre-warning
This alarm occurs when the battery reaches the EOD. After the pre-warning, the battery capacity allows two
minutes discharge at full load. The user can set the time ranging from 2 min～ 30 min, (2 min by default). Please
shut down the load timely
Battery mode The UPS is on battery, and the inverter starts
Battery
overtemp
Battery ambient temperature too high. Check that the battery ambient temperature is higher than setting value
40 ~ 60℃ (default: 50℃ )
Battery
replacement
timeout
The alarm will appear when the time (Battery replaced time adds the noted time of battery replacement) later than
the current system time. When the users set the noted time of battery replacement as disabled, the alarm will not
appear.
Battery
reversed
The battery positive and negative are reversed. Please reconnect the battery and check the battery cables
connection
Battery test fail
The battery low voltage is detected when the battery has manual or periodical self-test. Battery replacement is
recommended
Battery test
started
The battery periodic self-test and manual self-test started
Table 4.4 Alarm Messages
Vertiv | Liebert® GXT5™ Installer/User Guide
42