Operation Manual

FGT 433 A2
English - 57
10. Troubleshooting
Not working
 Are the batteries in the transmitter (13) and/or receiver (1)
empty? Insert new batteries where applicable.
The light on the LCD display (2) is dim.
 Are the batteries in the receiver (1) empty? Insert new batteries
where applicable.
The red LED (17) on the transmitter does not come on.
 Are the batteries in the transmitter (13) empty? Insert new
batteries where applicable.
The current core temperature (24) is shown as “- - -” on
the LCD display (2).
 Check that the connector (15) for the temperature sensor (14)
is correctly inserted into the socket (16). Insert it properly if not.
 The transmitter (13) and receiver (1) are too far apart. Move
them closer together.
 If necessary, switch the transmitter (13) and receiver (1) off for
about 3 seconds and then switch them back on again. This
should resolve the problem.
The LCD display (2) flashes with red back-lighting,
shows “HI” and a warning beep sounds.
 The maximum temperature for the temperature sensor (14) has
been exceeded. Press the “MEAT / STOP“ button (7) to stop
the beeping and the measurement.