User's Manual

20 US-EN
Use the included drill template (shown on the fold-out page) intended for mark-
ing drill holes.
Preparing the weather station for use
Removing the battery insulation strip:
Open the battery compartment
40
on the back of the weather station.
Remove the battery insulation strip.
Then close the battery compartment.
As soon as the battery insulation strip has been removed the weather station will
start receiving radio signal.
Note: Do not move the weather station while it is receiving the signal. This may
disrupt reception.
Connecting the weather station with the outdoor sensor and the
WWVB radio signal:
After removing the battery insulation strip the weather station will attempt to establish
a connection with the outdoor sensor. This process can take a few minutes. The
symbol will keep flashing for a few minutes. After successfully connecting with the
outdoor sensor, the selected channel symbol
27
will appear in the LC display with
the channel of the outdoor sensor (if necessary you can change the channel of the
282650_aur_Funk-Wetterstation_Content_US.indd 20 14.02.17 14:19