Safety Notes

9 US-EN
Depending on the volume and the age of the
battery, the operating time of the device is
5 hours when fully charged.
Open the protective cover
2
.
Insert the micro USB plug of the charging
cable
10
into the micro USB port
3
of the
Bluetooth
®
speaker. Insert the USB plug of the
charging cable into the USB port on a PC or
a USB adapter (not included).
Note: The signal LED
5
will light up red
while charging and goes out once charging
is completed. The charging time for a drained
battery is 6.5 hours.
Note: The speaker may be used while
charging. However, doing so will at a minimum
double the charging time.
Once charging is complete, remove the micro
USB plug of the charging cable and close the
protective cover so the device is splash-proof
again.
Using the Bluetooth speaker
Establishing a Bluetooth
®
connection:
Remove all plugs from the AUX stereo jack
4
before you establish a Bluetooth
®
radio link.
Press and hold the
Bluetooth button
9
for 2 seconds until the signal LED
5
flashes
blue and a sound sequence signal is emitted.
The speaker will now attempt to connect to the
playback device (e.g. smartphone or computer).
Switch on the playback device and approve
the connection. Please note the software
requirements for the playback device. The
signal LED will light up blue and emit a sound
signal sequence.
The speaker identification on the playback
device will be SBL 5.1 A1 (for model A).
The maximum range of the connection is
32.8ft (10 m), but may be reduced to the
geometry of the space (obstructing furniture,
walls, etc.).
The playback device must support Bluetooth
®
standard 4.2. Otherwise you may not be
able to use all the functions listed below.
Functions of the Bluetooth
speaker buttons
Start a playlist on your playback device. Set the
volume on the playback device to Maximum. The
volume on the Bluetooth
®
speaker can be adjusted
as described below. Music is played back through
the speakers
1
.
The Bluetooth
®
speaker has 4 buttons. They control
the following functions:
Button Function
- Hold 2 seconds: switch device on or o ff
- Push briefly during playback: pause
or resume
- Push briefly during playback: skip to
next song in the playlist
- H
old during playback: increase volum e.
A signal tone will sound when the maxi-
mum volume level has been reached.
- Press briefly during playback: replay
song
- Briefly push twice during playback:
previous song in the playlist
- Hold during playback: reduce volume
- Press and hold 2 seconds to enable /
disable the Bluetooth
connection.
Use Bluetooth speaker via
AUX stereo jack
Note: Music playback via cable takes priority
over music playback via Bluetooth
®
. Music play-
back from a Bluetooth
®
source is therefore inter-
rupted once the jack lead
11
is plugged into the
jack
4
.
The signal LED
5
lights up blue.
Music playback via the AUX stereo jack is
prioritized over playback via Bluetooth
®
.
Turn on the sound source.
If the Bluetooth
®
speaker is off, press and
hold the
button
6
until the blue LED
lights up and an audio signal can be heard.
Start playback on the sound source and ad-
just the volume to maximum volume. Adjust
310559_silv_Bluetooth-Lautsprecher_content_US.indd 9 31.10.18 11:09