User's Manual

INSTALL YOUR CAMERA

1. The best location is close to proximity of power outlet that the power cord can reach.

2. Stick the mounting template onto the wall, eave or roof. For concrete, brick or plywood siding,

use 6.3mm (1/4") drill bit to drill 3 pilot holes and insert anchors.

3. Use 16~20mm (5/8") drill bit to drill cable hole through the wall. If the wall is thick, you may

need to drill another hole in the interior.

4. Feed the camera cable into the hole and pull it out from the interior,

use sh rap to

pull cable through the wall if needed. caulk the hole properly to avoid water damage.

5. Connect camera cable to spliter (single way side). Connect Entheret cable and power cprd to

splitter (2 way side).

6. Connect Ethernet cable to wi router and plug in camera powe supply.

7. After 1 minute, you can watch video form app now.

Note:

Before mounting the camera, install the memeory card if you prefer recording video to local

storage.