User's Manual

16 US-EN
Remove the battery safety strip.
The outdoor sensor is now ready for use
and the control LED
29
illuminates briefly.
Close the battery compartment cover.
If this does not work, carry out a restart
of the temperature station if necessary. To
do this, press and keep pressed the
Z
Z
/ REGISTER button
21
(restart the
outdoor sensor only).
Preparing the temperature
station for use
Open the battery compartment
25
on the
back of the temperature station.
Remove the battery safety strip.
Close the battery compartment cover.
Connecting the temperature station
with the outdoor sensor and the
WWVB radio signal:
After removal of the battery safety strip, the tem-
perature station attempts to establish a connec-
tion with the outdoor sensor. This process can
take a few minutes. The Radio signal symbol
10
flashes. Once the temperature station has
successfully connected to the outdoor sensor, the
Radio signal symbol
10
stops flashing and
the temperature is shown in the LC display.
Note: If the temperature station does not
receive the signal from the outdoor sensor
within 3 minutes, the temperature station
automatically starts with the reception of the
radio time signal.
284995_aur_Temperaturstation_content_US.indd 16 21.03.17 16:49