Users Manual Part 2

16 US-EN
Initial Use
Note: First insert the batteries in the outdoor sensor, then the main
station.
Setting up the products
ATTENTION: First start the outdoor sensor, then the main station.
If possible, do not expose the outdoor sensor or main station to
direct sunlight. Place it on a horizontal, level surface or mount to
a plumb wall.
The main station can be hung by the main station eyebolt
4
or
flip out the stand
6
to place it on a horizontal, level surface.
Starting the outdoor sensor /
Changing batteries
Open the battery compartment
21
on the back of the outdoor
sensor by sliding the battery compartment cover
18
in the direction
of the arrow.
First remove the old batteries when changing batteries.
Insert the new batteries, type LR06, in the battery compartment
21
.
Please note the battery polarity. This is indicated in the battery
compartment.
Close the battery compartment cover. The signal LED
17
on the
front of the outdoor sensor will briefly light up. The signal LED will
then flash about twice a minute, indicating wireless transmission.
Starting the main station /
Changing batteries
Open the battery compartment cover
5
at the back of the main
station by pulling up on the tab at the bottom of the battery com-
partment.
First remove the old batteries when changing batteries.
296586_1901_aur_Funk-Wetterstation_Content_US.indd 16 24.06.19 11:47