Operating Instructions

AHFL 433 B2
US - EN
│
19 ■
Displaying the maximum/minimum
temperature/humidity
After connection to the power supply and the outdoor sensor
has been established, the maximum and minimum values for
temperature and humidity are automatically captured and stored
by the weather station.
♦ In basic mode, press the control surface
6 once. In
both display fields (3 and 7), the icon appears next
to the humidity and the highest measured value for both
inside and outside is shown.
♦ If you press the control surface
6 in basic mode, the
icon appears and the lowest measured value for both
inside and outside is shown.
♦ After about 5 seconds, the current values for inside and
outside are automatically shown once more.
♦ Press and hold the control surface
6 for about 3 seconds
to delete the stored values.
Changing the temperature unit on the outdoor
sensor
Upon delivery, the temperature unit is set to degrees Fahrenheit
( ) by default.
♦ Open the battery compartment o on the back of the
device by removing the battery compartment cover p.
♦ Press the °C/°F button u to change the temperature unit
on the outdoor sensor display e.
♦ Close the battery compartment o.
IB_314696_AHFL433B2_WeatherStation_LB9.indb 19 26.03.19 14:40