User's Manual

Librestream Onsight 1000/2000/2500 User Manual Answering & Initiating Calls
If a participant leaves the conference, the name of the participant leaving will
appear in a message as in the example below:
Î To refuse the call:
1. Tap Decline or press the End button
.
Î To enable automatic answering of a call:
1. From Main Menu > Configuration > Call Control > General, select “Enable auto answer”.
2. Any incoming call will now be answered automatically after three rings.
3.3 Initiating (Starting) a Call
Î To initiate or start a call from an Onsight device:
1. Press the Send button
to display a Local Contacts window listing the contacts that this Onsight device
has been set up to contact. This list is maintained by your Onsight system administrator.
2. Use the Navigation pad buttons, or tap the name to highlight the contact that you want to call. When you
select a name, the contact’s destination address appears in the field at the bottom of the window.
If the correct name does not exist, tap the field at the bottom of the window and use the on-screen keyboard
to enter the address of the contact you need to call. Consult your Onsight system administrator for details.
3. When the desired network address is displayed in the Network address field either tap Dial with the stylus or
press the Send button
to initiate the call.
You will hear the outgoing rings or a busy signal on the Onsight device just as you would on a mobile phone.
When the call is answered, you can start talking, just like a mobile phone. If the call is declined, a message will be
displayed indicating the reason.
28