User's Manual

Librestream Onsight 1000/2000/2500 User Manual Onsight Device Basic Operation
2.6.2 Onsight 2000/2500
Before opening the Onsight 2000Ex/2500Ex battery cover, you
must read the Onsight 2000/2500 Regulatory and Safety Guide.
Î To insert or replace the Onsight 2000/2500 SD memory card:
Do not open the battery door while recording. This can corrupt the memory
card data.
1. Ensure the device is powered off before proceeding. See paragraph 2.4, Turning Power On or Off, on page
21 for instructions.
2.
Open the battery compartment door using the stylus screwdriver, and remove the battery by sliding the
battery back towards the end of the battery compartment and then lifting out the battery.
Battery door
thumb screw
25
SD memor
y card
A
ccess doo
r
3. If there is already an SD memory card in place, flip open the access door to release the card from the slot.
4. Pull the card out.
5. Place the new card in the slot (at a slight angle to engage the contacts first) and then gently push the card
down until it is seated.
6. Close the access door.
7. Re-insert the battery and close the compartment door.