User's Manual

LibreStream n_sight MCD2000 User Manual
36
• IP calls - SIP
• Integrated 802.11 b/g radio
• RJ-45 10/100 Ethernet
POWER
• Rechargeable 2400 mAH Li-Ion
battery pack
• External power
• Input: 12 VDC @ 1A
• External Power Adapter
Specifications:
• Output Voltage: 12 VDC @
1.5A
• Rated Input Voltage:
100 – 240 VAC
• Input Voltage Range:
90 – 264 VAC
• Rated Input Frequency:
50 – 60 Hz
• Input Frequency Range:
47 – 63 Hz
OPERATING ENVIRONMENT
• Temperature:
• Operating: 0° to 40° C
• Storage: –20° to 60° C
• Operating humidity: 5 – 80%
(non-condensing)
10.1.1. Service Information
If you encounter difficulties with the
MCD, contact your corporate
technical support department. They
will determine whether the problem
exists within the network
infrastructure or the n_sight
equipment and will contact
LibreStream Support. See page 45
for LibreStream contact information.
11. Safety & Regulatory
Information
General
• Do not attempt to service this
equipment. All repairs must be
done by an authorized
LibreStream service depot.
• Do not block or insert objects
into the air vents or other
openings in the equipment. Doing
so may damage internal
components and may cause fire
or shock hazards.
• Use only a LibreStream-supplied
power adapter with the
equipment. Use of other adapters
may cause fire or explosion
hazards.
• Operate the external power
adapter in a well ventilated area.
Do not cover the power adapter
with papers or any other items as
the adapter may become hot.
Battery
CAUTION!
Risk of explosion if battery is
replaced by an incorrect type or
installed incorrectly.
• Observe the correct polarity
when changing the lithium
battery. Install battery according
to the manufacturer’s product
documentation.
• Replace battery only with the
same type as recommended by
the manufacturer.
• Dispose of used batteries
according to the manufacturer’s
product documentation and local
disposal requirements.
• Use only LibreStream-supplied
batteries with the MCD. Use of
other types may increase the risk
of fire or explosion or damage to
the equipment.
• Do not store the battery in places
where metallic objects may come
in contact with the battery
terminals (e.g. in a pocket with
keys, in a drawer with paper
clips, etc.). The resulting short-
circuit can cause extremely high
temperatures that may damage
the battery and cause burns or
fires.
• Do not attempt to disassemble
the battery. The battery poses a
burn hazard if handled
improperly. Immediately dispose
of a damaged or leaking battery.
• Do not store or leave the MCD or
MCD battery near a heat source
(e.g. radiator, stove, heater,
automobile dashboard, etc.) as
the battery may explode or
ignite.
Battery Disposal
The MCD2000 uses a Lithium-Ion
battery and must be disposed of
properly:
• The battery must not be disposed
with household or office waste.
• Do not dispose of the battery in a
fire as the battery may explode.
• Contact your local waste disposal
agency for the address of the
nearest battery disposal location.
European Regulatory
Information
This product meets the essential
health and safety requirements and
is in conformity with the relevant EU
Directives listed below:
• R&TTE 1999/5/EC
• EU Low Voltage Directive
72/23/EEC
• EU EMC Directive 89/336/EEC
This product has been tested and
found to comply with EN 61000-6-
2:1999 Immunity for Industrial
Environments. When in the presence
of high levels of radio-frequency
electromagnetic fields, the user may
notice interference within the audio
or video content present on the
equipment. If this occurs the user
should re-orient the equipment or
increase the separation between the
equipment and the interfering
source. If an external audio headset
is being used and is the receiving
source of the interference, the user
may experience improved
performance by using a headset
which has been tested and found to
comply with EN61000-6-2:1999
Immunity for Industrial
Environments.
FCC Class B Notice
This product has been tested and
found to comply with the limits for a
Class B digital device, pursuant to
Part 15 of the FCC Rules. These rules
are designed to provide reasonable
protection against harmful
interference in a residential
installation. This product generates,
uses, and can radiate radio frequency
energy, and if not installed and used
in accordance with the instructions,
may cause harmful interference with
radio communications. However,
there is no guarantee that
interference will not occur in a
particular installation. If the