User's Manual

LibreStream n_sight MCD2000 User Manual
6
2. MCD Basic Operation
2.1. Charging the Battery
New batteries should be charged prior to first use. To do this, plug in the
external power adaptor and allow the battery to charge until the orange
battery indicator extinguishes (up to eight hours). The internal battery
charger will shut itself off to prevent overcharging once the battery is fully
charged.
Note that the MCD shuts itself off when battery power is low.
• If the unit is on, and an Operator is using it in an active call, a warning
message appears so that the Operator has time to plug the MCD in to
the external power adapter, or end the call before the MCD shuts off.
• If the unit is in Standby, it simply shuts itself off.
• If the unit is off, it cannot be started when the battery is low.
To check current battery levels, press the Display button once and check
the Session information at the bottom of the Viewfinder. See page 22 for
more information on Viewfinder and Display modes.
2.2. Inserting or Replacing the Battery
Important: Before using this device for the first time you must install and
charge the battery.
1. Open the battery compartment door using the stylus screwdriver.
Figure 1
2. Align the contact end of the battery with the small recess lines in the
battery compartment, keeping the opposite end of the battery up.
Recess lines
Battery door thumbscrew