User's Manual

Unpacking
When you unpack the MCD2000 you should find:
• MCD2000
• External Power Adapter
• Stylus (2)
• Battery
• Wrist Strap
• I/O Cover
• Power Plug
• Lens Cover
• Quick Start Guide (this
document)
• CD of user manuals, end
user license, copyright,
and MCA software
• Safety and regulatory
information
Before using the MCD2000-Ex, you must read the
enclosed safety and regulatory information.
Important: Before using this device for the first time you
must install and charge the battery.
Parts of the MCD2000
freedom to collaborate
Button Function
Start or accept call (Send)
End a call
Volume up
Mic mute
Volume down
Illumination ring on/off
Enter
Mobile Collaboration Device
PN 400096-00
July 2008
Accessories
Navigation Pad
Open the battery
compartment door using
the stylus screwdriver.
Align the contact end of
the battery with the small
recess lines in the battery
compartment.
Slide the battery upward
and rotate downward to
place in battery well. When
the battery is sitting flat
on the compartment floor,
slide the battery towards
the compartment door until
seated.
Close the battery
compartment and tighten
the screw. Note that the
door will not close if the
battery is not fully inserted.
Connect the external power
plug and charge the battery
until the orange LED turns
off (up to eight hours).
Power plug
I/O cover
Sled
Optional
Charging the Battery
Viewfinder
Navigation pad
Speaker
Streaming indicator
Battery door (SD slot inside)
Headset connector
Still image
capture
Microphone
Lens
Illumination ring
LED indicators
Tripod mount
I/O connector
Streaming on/off
Recording on/off
Display mode
Focus
Function
Power
Stylus w/screwdriver
Recess lines