Operation Manual

Figure 50: Position and Size dialog – Rotation page
– Default settings – select where you want to place the pivot point. Default position is
the center of the object. Changing the rotation pivot point is only valid for single use.
The pivot point is reset to default settings when you close the Position and Size
dialog.
• Rotation – specify the number of degrees that you want to rotate the selected object, or
click in the rotation grid.
– Angle – enter the number of degrees that you want to rotate the selected object. This
option is only available in the Position and Size dialog.
– Default settings – click on the indicator to rotate the object. The number of degrees is
shown in the Angle box as you rotate the indicator. This option is only available in the
Position and Size dialog.
– Rotation – click on the indicator to rotate the selected object, or set the angle in the
text box, or select a a predetermined angle from the drop down list. This option is only
available in the Position and Size subsection on the Sidebar.
– Flip – flip the selected object either vertically or horizontally about its central axis. This
option is only available in the Position and Size subsection on the Sidebar.
Slant and corner radius
To accurately set the corner radius or slant angle of an object, click on the Slant & Corner Radius
tab of the Position and Size dialog (Figure 51). Options for slant and corner radius are only
available in the Position and Size dialog.
Figure 51: Position and Size dialog – Slant & Corner Radius page
Chapter 3 Working with Objects and Object Points 53