User Manual
Table Of Contents
- 1. Introduction
- 2. Libre Wireless Technologies’ EVK
- 3. Firmware Upgrade
- 4. Network Configuration
- 5. Configuring Non-Volatile-Item
- 6. Features
- 6.1. Libre APP for Android
- 6.2. DDMS
- 6.3. Source Switching
- 6.4. Failsafe Mechanism
- 6.5. Software Security
- 6.6. Airplay®
- 6.7. Cast For Audio
- 6.8. Spotify Connect
- 6.9. AUX-In Support
- 6.10. USB Playback
- 6.11. DLNA ® / DMR
- 6.12. LUCI Over UART
- 6.13. Switch between Wired and wireless modes
- 6.14. TCP / IP Tunneling
- 6.15. Wi-Fi Scan Result
- 6.16. Device Name Configuration
- 6.17. Music Services
- 6.18. Telnet
- 6.19. Roon Music
- 7. Appendix
LS9 User Guide
Libre Wireless Technologies User Guide : LS9 / LS9AD, Ver. 5.3 Page 35 of 75
Libre Confidential
4.3. WPS Trigger from Command Line
To setup a wireless network using WPS proceed as below
Step 1. On system boot, enter the command #wpa_cli wps_pbc in device
terminal
Step 2. Trigger (Press Once) Setup button in the Access Point.
Device connects to the Network of the Access Point.
Step 3. To know the newly acquired IP execute command #netcfg in the device
terminal
End--
4.4. WPS Trigger from LUCI
You can setup a wireless network for the LS-Enabled speaker, using the LUCI Message-
Box #141. Message-Box #141 is used by Host to trigger WPS mode.
For more information see section 6 in LUCI Technical Note,
LibreWirelessTechNote - LS_Light_Weight_Universal_Control_Interface.