User Manual
Table Of Contents
- 1. Introduction
- 2. Libre Wireless Technologies’ EVK
- 3. Firmware Upgrade
- 4. Network Configuration
- 5. Configuring Non-Volatile-Item
- 6. Features
- 6.1. Libre APP for Android
- 6.2. DDMS
- 6.3. Source Switching
- 6.4. Failsafe Mechanism
- 6.5. Software Security
- 6.6. Airplay®
- 6.7. Cast For Audio
- 6.8. Spotify Connect
- 6.9. AUX-In Support
- 6.10. USB Playback
- 6.11. DLNA ® / DMR
- 6.12. LUCI Over UART
- 6.13. Switch between Wired and wireless modes
- 6.14. TCP / IP Tunneling
- 6.15. Wi-Fi Scan Result
- 6.16. Device Name Configuration
- 6.17. Music Services
- 6.18. Telnet
- 6.19. Roon Music
- 7. Appendix
LS9 User Guide
Libre Wireless Technologies User Guide : LS9 / LS9AD, Ver. 5.3 Page 24 of 75
Libre Confidential
4. Network Configuration
You can configure the network to LS9 module in the following ways.
Wireless Network Setup Using WAC and SAC Method
Wireless Network Setup Using Webserver Method
Speakers present in different Wi-Fi frequency bands cannot form a
DDMS Group.
For example, If Speaker A is in Wi-Fi frequency band of 2.4GHz and
Speaker B is in Wi-Fi frequency band of 5GHz, then you cannot form a
DDMS Group of Speaker A and Speaker B.
Whereas, If Speaker A and Speaker B are in same frequency band
(Speaker A and Speaker B are in 2.4GHZ or Speaker A and Speaker B are
in 5GHZ), then they form a DDMS Group.
4.1. Wireless Network Setup Using WAC and SAC
4.1.1 Wireless Network Setup Using WAC
To setup a wireless network using Wireless Accessory Configuration (WAC) proceed as
below:
Step 1. Short-Press the Setup-Button on LS9 EVK to trigger WAC mode.
Step 2. On an iOS device running iOS, go to Settings > Wi-Fi > SET UP NEW
DEVICE
The WAC speaker is listed. For example, Libre <MacID>.