User's Manual
Table Of Contents
- 1. Introduction
- 2. Libre Wireless Technologies’ EVK
- 3. Firmware Update
- 4. Configuring Non-Volatile-Item
- 5. Key Button Functionality
- 6. Network Configuration
- 7. Features
- 7.1. Libre APP for Android
- 7.2. DDMS
- 7.3. Software Security
- 7.4. Source Switching
- 7.5. Failsafe Mechanism
- 7.6. Autosense of Audio CODEC
- 7.7. AUX-In Support
- 7.8. Airplay®
- 7.9. DLNA ® / DMR
- 7.10. Miracast
- 7.11. SD-Card Playback
- 7.12. i-Device playback over USB
- 7.13. Favourites
- 7.14. USB Playback
- 7.15. TCP / IP Tunneling
- 7.16. Wi-Fi Scan Result
- 7.17. Device Name Configuration
- 7.18. Switch between Wired and wireless modes
- 7.19. Pair / Share credentials
- 7.20. Multiple SSID
- 7.21. Zone Volume.
- 7.22. Music Services
- 7.23. Telnet
- 8. Appendix
LS6 User Guide
Libre Wireless Technologies User Guide: LS6, Ver. 6.0 Page 39 of 81
Libre Confidential
Step 3. In Select Your Network section, Select the Access Point (AP) to be connected,
from Select your Network drop-down list and Click Save
Device reboots and connects to the new network and acquires new IP
Figure 6.2.1-2: Network Configuration
End --
You can also connect the device to the network of your choice by setting the Static IP for the
device from the device web page.
Static IP address is a known IP address pre-allocated to the device. Static IP does not change
and the device will have the same IP always.
Step 1. Select the Access Point from Select Your Network drop-down list.
Step 2. Enable Static IP ON / OFF settings.
Step 3. Enter IP Address, Net Mask, Gateway, Primary DNS, Secondary DNS
details as shown in the below screenshot, and click Save