User's Manual
Table Of Contents
- 1. Introduction
- 2. Libre Wireless Technologies’ EVK
- 3. Firmware Update
- 4. Configuring Non-Volatile-Item
- 5. Key Button Functionality
- 6. Network Configuration
- 7. Features
- 7.1. Libre APP for Android
- 7.2. DDMS
- 7.3. Software Security
- 7.4. Source Switching
- 7.5. Failsafe Mechanism
- 7.6. Autosense of Audio CODEC
- 7.7. AUX-In Support
- 7.8. Airplay®
- 7.9. DLNA ® / DMR
- 7.10. Miracast
- 7.11. SD-Card Playback
- 7.12. i-Device playback over USB
- 7.13. Favourites
- 7.14. USB Playback
- 7.15. TCP / IP Tunneling
- 7.16. Wi-Fi Scan Result
- 7.17. Device Name Configuration
- 7.18. Switch between Wired and wireless modes
- 7.19. Pair / Share credentials
- 7.20. Multiple SSID
- 7.21. Zone Volume.
- 7.22. Music Services
- 7.23. Telnet
- 8. Appendix
LS6 User Guide
Libre Wireless Technologies User Guide: LS6, Ver. 6.0 Page 11 of 81
Libre Confidential
Figure 2-2: LS6 EVK (v3.0) Peripherals
2.1. LS6 EVK Setup
To setup the LS6 EVK and get started proceed as below
Step 1. Ensure the LS6 module is inserted in the EVK
Step 2. Connect the USB-to-Serial Cable from Serial port of EVK to USB port of
Laptop
Step 3. Connect the Power adaptor to DC Jack on EVK
Step 4. Power On the EVK, using ON/ OFF Switch
Step 5. Open the terminal tool (Hyper Terminal / Teraterm) on your laptop
Step 6. Configure the Serial settings, as below
- Baud Rate at 57600
- Data Bits at 8
- Parity at None
- Stop Bits at 1