User's Manual

LS5B User Guide
Libre Wireless Technologies User Guide: LS5B, Ver. 2.9 Page 39 of 78
Libre Confidential
Figure 6.2.1-3: Network Configuration using Static IP
Use any IP address from the Access Point IP’s address range which is
not assigned to any client device already.
Device reboots and connects to the network and acquires the static IP as defined.
Step 4. To know the IP address of the device, execute command #netcfg in the
device terminal
End--
6.2.2. LS-Configure Method
To setup wireless network using LS-Connect proceed as below
Step 1. Press and hold the Setup button for 3 seconds on the EVK to trigger LS-
Configure.
Device enters “AP” mode and is available in the Wi-Fi network list as LS-Configure_xxxxxx
Step 2. From the network list Select LSConfigure_xxxxxx and connect the laptop to
the network.