User's Manual

LS5B User Manual
Libre Wireless Technologies User Manual: LS5B, Ver. 1.0 Page 49 of 89
Libre Confidential
Figure 6-14: Network Configuration using Static IP
Step 3. To know the IP address of the device execute command #netcfg in the device
terminal
End--
6.2.2. LS-Connect Method
To setup wireless network using LS-Connect proceed as below
Step 1. Enter Command #startwac & in device terminal to trigger LS-Connect
Or
Press and hold the Setup button for 3 seconds on the EVK
Device enters “AP” mode and is available in the Wi-Fi network list as LS-Configure_xxxxxx
Step 2. From the network list Select LSConfigure_xxxxxx and connect the laptop to
the network.
Step 3. Enter the following URL in the address bar of your browser 192.168.43.1
webpage shows Network status as shown in Figure 6-4.