User's Manual

LS5B User Manual
Libre Wireless Technologies User Manual: LS5B, Ver. 1.0 Page 45 of 89
Libre Confidential
6.1.3. WAC / SAC Trigger Behaviour in DDMS Mode and Non-DDMS
Mode
This sections explains different behaviours of the speaker for network configuration when
WAC / SAC is triggered.
For details on the network configuration using WAC / SAC refer Section 6.1 and Section 6.2.
Scenario 1
Precondition
LS-Enabled speaker is in Non-DDMS Mode and is not connected
to AP.
Action
WAC / SAC is triggered using the Setup Button (Press and Hold for
three seconds) in LS EVK or through Message-Box 142.
Result
LS-Enabled Speaker enters WAC / SAC mode for Network
Configuration.
Scenario 2
Precondition
LS-Enabled speaker is in Non-DDMS Mode and is connected to
AP.
Action
WAC / SAC is triggered using the Setup Button (Press and Hold for
three seconds) in LS EVK or through Message-Box 142.
Result
LS-Enabled Speaker enters WAC / SAC mode for Network
Configuration.
Scenario 3
Precondition
LS-Enabled speaker is in Non-DDMS Mode and is not connected
to AP.
Action
1. Reboot the Speaker. Currently the speaker is in Non-DDMS
Mode.
2. Configure the speakers to DDMS-Mode i.e. either in SA
Mode/HN Mode (refer to DDMS usability guide).