SDS

SAFETY DATA SHEET
The Libman Company LIBMAN FLOOR POLISH #2055, #2067
The Libman Company Page 3 of 7
NFPA RATING SYSTEM HMIS RATING SYSTEM
HAZARDOUS MATERIAL IDENTIFICATION SYSTEM
Flammability
HEALTH HAZARD (BLUE)
1
FLAMMABILITY HAZARD (RED)
0
Health Reactivity
PHYSICAL HAZARD (YELLOW) 0
PROTECTIVE EQUIPMENT
EYES RESPIRATORY HANDS BODY
Other
See Sect 8
See Sect
8
For Routine Industrial Use and Handling Applications
Hazard Scale: 0 = Minimal 1 = Slight 2 = Moderate 3 = Serious 4 = Severe * = Chronic hazard
SECTION 6. ACCIDENTAL RELEASE MEASURES
6.1 PERSONAL PRECAUTIONS, PROTECTIVE EQUIPMENT AND EMERGENCY PROCEDURES:
Use cautious judgment when cleaning up spill. Wear suitable protective clothing, gloves and eye/face protection.
6.2 ENVIRONMENTAL PRECAUTIONS:
Construct a dike to prevent spreading. Keep out of sewers, storm drains, surface waters, and soils.
6.3 SPILL AND LEAK RESPONSE:
Small spills: Collect material via broom or mop. Place in tightly sealed containers for proper disposal.
Large spills: Approach spill areas with caution. If liquid was introduced, create a dike or trench to contain material.
Soak up with absorbent material such as clay, sand or other suitable non-reactive material. Place in leak-proof
containers. Seal tightly for proper disposal. Dispose of in accordance with U.S. Federal, State, and local hazardous
waste disposal regulations and those of Canada and its Provinces, those of Australia, Japan and EU Member States
(see Section 13, Disposal Considerations).
SECTION 7. HANDLING and STORAGE
7.1 PRECAUTIONS FOR SAFE HANDLING:
To prevent skin and eye contact under the foreseeable conditions of use, wear appropriate protective clothing and
safety eyewear. Wash thoroughly after handling.
7.2 STORAGE AND HANDLING PRACTICES:
Keep away from incompatible materials. Protect containers from physical damage.
7.3 SPECIFIC USES:
Helps hide minor scuffs that occur on from daily wear and tear on hardwood floors.
SECTION 8. EXPOSURE CONTROLS / PERSONAL PROTECTION
8.1 EXPOSURE PARAMETERS:
Chemical Name CAS# ACGIH TLV OSHA TWA
Water 7732-18-5
Not listed Not listed
Hydrocarbon Wax Emulsion 9010-77-9
2 ppm 2 ppm
8.2 EXPOSURE CONTROLS:
VENTILATION AND ENGINEERING CONTROLS: Use with adequate ventilation to ensure exposure levels are
maintained below the limits provided above.
The following information on appropriate Personal Protective Equipment is provided to assist employers in complying
with OSHA regulations found in 29 CFR Subpart I (beginning at 1910.132) or equivalent standard of Canada, or
standards of EU member states (including EN 149 for respiratory PPE, and EN 166 for face/eye protection), and those
of Japan. Please reference applicable regulations and standards for relevant details.
0
-
0
1