SDS

SAFETY DATA SHEET
The Libman Company LIBMAN CONCENTRATED GLASS CLEANER #10040, #1063
The Libman Company Page 4 of 7
SECTION 7. HANDLING and STORAGE
7.1 PRECAUTIONS FOR SAFE HANDLING:
To prevent skin and eye contact under the foreseeable conditions of use, wear appropriate protective clothing and
safety eyewear. Wash thoroughly after handling.
7.2 STORAGE AND HANDLING PRACTICES:
Keep away from incompatible materials. Protect containers from physical damage.
7.3 SPECIFIC USES:
Cleaning surfaces
SECTION 8. EXPOSURE CONTROLS / PERSONAL PROTECTION
8.1 EXPOSURE PARAMETERS:
Chemical Name CAS# ACGIH TLV OSHA TWA
Sodium Laureth Sulfate 9004-82-4 Not established Not established
Methylchloroisothiazolinone,
Methylisothiazolinone
26172-55-4 /
2682-20-4
Not established Not established
8.2 EXPOSURE CONTROLS:
VENTILATION AND ENGINEERING CONTROLS: Use with adequate ventilation to ensure exposure levels are
maintained below the limits provided above.
The following information on appropriate Personal Protective Equipment is provided to assist employers in complying
with OSHA regulations found in 29 CFR Subpart I (beginning at 1910.132) or equivalent standard of Canada, or
standards of EU member states (including EN 149 for respiratory PPE, and EN 166 for face/eye protection), and those
of Japan. Please reference applicable regulations and standards for relevant details.
RESPIRATORY PROTECTION: Not required for properly ventilated areas. Maintain airborne contaminant
concentrations below guidelines listed above, if applicable. If necessary, use only respiratory protection authorized in
the U.S. Federal OSHA Respiratory Protection Standard (29 CFR 1910.134), equivalent U.S. State standards,
Canadian CSA Standard Z94.4-93, the European Standard EN149, or EU member states.
EYE PROTECTION: Safety glasses or goggles are required. If necessary, refer to U.S. OSHA 29 CFR 1910.133,
Canadian Standards, and the European Standard EN166, Australian Standards, or relevant Japanese Standards.
HAND PROTECTION: Chemical resistant gloves are required to prevent skin contact. If necessary, refer to U.S.
OSHA 29 CFR 1910.138, the European Standard DIN EN 374, the appropriate Standards of Canada, Australian
Standards, or relevant Japanese Standards.
BODY PROTECTION: Use body protect appropriate to task being performed. If necessary, refer to appropriate
Standards of Canada, or appropriate Standards of the EU, Australian Standards, or relevant Japanese Standards. If a
hazard of injury to the feet exists due to falling objects, rolling objects, where objects may pierce the soles of the feet
or where employee’s feet may be exposed to electrical hazards, use foot protection, as described in U.S. OSHA 29
CFR 1910.136.
SECTION 9. PHYSICAL and CHEMICAL PROPERTIES
9.1 INFORMATION ON BASIC PHYSICAL AND CHEMICAL PROPERTIES:
APPEARANCE (Physical State) and COLOR: This product is a dark blue liquid
ODOR: Surfactant eucalyptus mint
ODOR THRESHOLD: Not Available
pH: 6-8
MELTING/FREEZING POINT: Not Available
BOILING POINT: Not available
FLASH POINT: Not available
EVAPORATION RATE (n-BuAc=1): Not Available
FLAMMABILITY (SOLID, GAS): Not Applicable
UPPER/LOWER FLAMMABILITY OR EXPLOSION LIMITS: Not Available
VAPOR PRESSURE (mm Hg @ 20°C (68F): Not Available
VAPOR DENSITY: Not Available
RELATIVE DENSITY: Not Available
SPECIFIC GRAVITY: Nearly 1