Owner's Manual
Table Of Contents
- Quick Start Guide
- Installation and Operation Guide
- Product Overview
- Package Contents
- SKYPLAY-DFS-S Features and Connections
- SKYPLAY-DFS-R Features and Connections
- IR Remote
- Installation Instructions
- Frequently Asked Questions
- Troubleshooting
- SKYPLAY-DFS Technical Specifications
- SKYPLAY-DFS-EU Technical Specifications
- Spec Sheet
SKYPLAY-DFS Installaon Guide
19
Troubleshoong
• Make sure both transmitter and receiver are powered on.
• Make sure pairing units are the only SKYPLAY devices currently powered on.
• Bring the transmitter and receiver closer together but no closer than 1 meter.
• Keep the number of solid walls between the transmitter and receiver to a minimum.
• Make sure the receiver is powered on.
• Make sure the monitor is powered on.
• Make sure the receiver is properly connected to the display.
• Make sure the display is set to display video from the right source (HDMI1, HDMI2 etc.).
• Reboot the receiver.
• Unplug and then re-plug the HDMI cable between the receiver and the display.
• Replace the HDMI cable.
• Make sure the video resolution is supported by the display.
• Unplug and then re-plug the HDMI cable between the receiver and the display.
• Unplug and then re-plug the HDMI cable between the transmitter and the source.
• Bring the transmitter and receiver closer together but no closer than 1 meter.
• Keep the number of solid walls between the transmitter and receiver to a minimum.
• Power cycle the SKYPLAY-DFS.
• Check the mute and audio volume settings on the display.
• Verify the audio format setting on the source is compatible with the SKYPLAY-DFS.
• Make sure the transmitter is properly connected to the source.
• Make sure the network LED is powered on.
• Make sure the source is powered on.
• Unplug and then re-plug the transmitter to the source.
Pairing Fails
No Signal on the Display
Abnormal Color or Noise on the Display
No Audio
No Video over the Wireless Link