Owner's Manual
Table Of Contents
- Quick Start Guide
- Installation and Operation Guide
- Product Overview
- Package Contents
- SKYPLAY-DFS-S Features and Connections
- SKYPLAY-DFS-R Features and Connections
- IR Remote
- Installation Instructions
- Frequently Asked Questions
- Troubleshooting
- SKYPLAY-DFS Technical Specifications
- SKYPLAY-DFS-EU Technical Specifications
- Spec Sheet
SKYPLAY-DFS Installaon Guide
14
Point-to-Many Pairing (Signal Distribuon)
Many-to-Point Pairing (Signal Switching)
Below are the steps necessary to pair additional SKYPLAY-DFS receivers to the transmitter for a point-to-many installation.
The maximum number of active receivers that may be connected to a single transmitter is four.
1. Power o all paired SKYPLAY-DFS receivers.
2. Repeat the process for point-to-point pairing.
3. Apply power to all receivers after pairing is complete on all units.
Pairing multiple transmitters to a single receiver is performed with the remote control.
1. Power o all paired SKYPLAY-DFS transmitters.
2. Apply power to the unpaired SKYPLAY-DFS-S.
3. Select And New Video Source from the Setup menu.
4. Repeat the process for point-to-point pairing.
5. Apply power to all transmitters after pairing is complete on all units.
6. Use the remote control to switch between available transmitters.