Owner's Manual

2
Please review the location of all ports before proceeding with installation.
1. Connect an HDMI cable between the HDMI port on the source device to be
extended and the HDMI Input port on the SKYPLAY-DFS-S.
2. Plug the IR emitter into the IR Out port on the SKYPLAY-DFS-S.
3. Remove the adhesive on the IR emitter. Attach the emitter to the IR window on
the source device.
4. Plug the power supply into a wall outlet. Do not apply power to the SKYPLAY-DFS
transmitter at this time.
In addition to resting on a at surface, the SKYPLAY-DFS-S can be mounted on a
wall or furniture. Please see page 4 for mounting guidelines.
SKYPLAY-DFS-S
TX / TRANSMITTER
Link
Video
Power
Register
Reset
5vDC 1.5A Max
Service
HDMI Input IR Out
Top
Front
Right
Link LED–Indicates network status. LED
will be solid during normal operation.
Video LED–Indicates the video stream is
present.
Power LED–Indicates power is applied to
transmitter.
Register Button–Pressed during initial
conguration to pair with receiver.
Reset Button–Press for soft reboot of
transmitter.
Power Input–5V DC power input for
supplied power supply.
Service Port–Only used for rmware
updates.
HDMI Input–HDMI input port to connect
to source device.
IR Out Port–Remote control of source
from wireless receiver.
SKYPLAY-DFS-S Setup