Product Specification LowPro-Series Low Profile Sewage System LITERS PER MINUTE 0 100 200 300 400 500 6 24 5.5 22 LowPro51LP 5 20 4.5 18 TOTAL HEAD IN FEET 3.5 14 LowPro41LP 12 3 2.5 10 8 2 6 1.5 4 1 2 0.5 TOTAL HEAD IN METERS 4 16 0 0 0 20 40 60 80 100 120 140 160 GALLONS PER MINUTE LowPro-Series_P1 R3/25/2019 © Copyright 2019 Liberty Pumps, Inc. All rights reserved. Specifications subject to change without notice.
LowPro-Series Dimensional Data TOP VIEW 12-1/2” 17” 2” NPT vent 24-1/2” 2” NPT discharge 12-1/4” 7” 5” 3-3/4” 42” SIDE VIEW 29-1/2” Optional inlet location area for lavatory or shower. 14-5/8” 5-1/4” Minimum height from bottom of tank to bottom of optional inlet line. LowPro-Series_P2 R3/25/2019 © Copyright 2019 Liberty Pumps, Inc. All rights reserved. Specifications subject to change without notice.
LowPro-Series Electrical Data FULL LOAD LOCKED AMPS ROTOR AMPS MODEL HP VOLTAGE PHASE LowPro41LP 4/10 115 1 12 LowPro51LP 1/2 115 1 12 HZ RPM DISCHARGE 22.5 60 1725 2” 22.
LowPro41LP Specifications 1.01 GENERAL The contractor shall provide labor, material, equipment, and incidentals required to provide _________ (QTY) centrifugal pumps as specified herein. The pump models covered in this specification are Model LE41LP single-phase pumps as manufactured by Liberty Pumps. 2.01 OPERATING CONDITIONS Each submersible pump shall be rated at 4/10 hp, 115 Volts, single-phase, 60 Hz, 1725 RPM.
9.01 CONTROLS All units are supplied with CSA and UL approved float switches. 10.01 PAINT The exterior of the pump casting shall be protected with powder coat paint. 11.01 SUPPORT The pump shall have cast iron support legs, enabling it to be a free standing unit. The legs will be high enough to allow 2” solids to enter the volute. 12.01 SERVICEABILITY Components required for the repair of the pump shall be shipped within a period of 24 hours. 13.
LowPro51LP Specifications 1.01 GENERAL The contractor shall provide labor, material, equipment, and incidentals required to provide_________ (QTY) centrifugal pumps as specified herein. The pump models covered in this specification are Model LE51LP single-phase pumps as manufactured by Liberty Pumps. 2.01 OPERATING CONDITIONS Each submersible pump shall be rated at 1/2 hp, 115 Volts, single-phase, 60 Hz, 1725 RPM.
9.01 CONTROLS All units can be supplied with CSA and UL approved float switches. 10.01 PAINT The exterior of the casting shall be protected with powder coat paint. 11.01 SUPPORT The pump shall have cast iron support legs, enabling it to be a free standing unit. The legs will be high enough to allow 2” solids to enter the volute. 12.01 SERVICEABILITY Components required for the repair of the pump shall be shipped within a period of 24 hours. 13.
