Pump Specifications HT450 Series High Temperature Submersible Sump Pump 2” Solids handling 77º F 180º F HT450_P1 R10/13/2015 ©Copyright 2015 Liberty Pumps Inc. All rights reserved. Specifications subject to change without notice.
HT450-Series Dimensional Data HT450_P2 R10/13/2015 ©Copyright 2015 Liberty Pumps Inc. All rights reserved. Specifications subject to change without notice.
HT450 - Series Electrical Data MODEL HP VOLTAGE PHASE FULL LOAD AMPS HT450 1/2 115 1 7.3 1/2 115 1 7.
HT450 - Series Specifications 1.01 GENERAL: The contractor shall provide labor, material, equipment, and incidentals required to provide (QTY) centrifugal pumps as specified herein. The pump models covered in this specification are Series HT450 single phase pumps. The pump furnished for this application shall be model ______________as manufactured by Liberty pumps. 2.01 OPERATING CONDITIONS: Each submersible pump shall be rated at 1/2 hp, 115 volts, single phase, 60 Hz., 3450 RPM.
7.01 SEALS The pump shall have an engineered double lip seal with stainless steel springs. The motor plate / housing interface shall be sealed with a Buna-N o-ring. 8.01 IMPELLER The impeller shall be engineered polymer, with pump out vanes on the back shroud to keep debris away from the seal area. It shall be threaded to the motor shaft. 9.01 CONTROLS The pump can be supplied with a piggy back type wide angle float switch or manual.
