Pump Specifications HT40 Series High Temperature Submersible Sump Pump 2” Solids handling WATER TEMP. 77˚F WATER TEMP. 200˚F HT40_P1 R10/13/2015 ©Copyright 2015 Liberty Pumps Inc. All rights reserved. Specifications subject to change without notice.
HT40-Series Dimensional Data HT40_P2 R10/13/2015 ©Copyright 2015 Liberty Pumps Inc. All rights reserved. Specifications subject to change without notice.
HT40-Series Electrical Data MODEL HP VOLTAGE PHASE FULL LOAD AMPS THERMAL OVERLOAD TEMP STATOR WINDING CLASS CORD LENGTH FT DISCHARGE AUTOMATIC HT41A 4/10 115 1 12 23 150˚C / 302˚F F 10 1 1/2 YES HT41A -2 4/10 115 1 12 23 150˚C / 302˚F F 25 1 1/2 YES HT41M 4/10 115 1 12 23 150˚C / 302˚F F 10 1 1/2 NO HT41M-2 4/10 115 1 12 23 150˚C / 302˚F F 25 1 1/2 NO LOCKED ROTOR AMPS HT40-Series Technical Data IMPELLER SOLIDS HANDLING SIZE PAINT HIGH TEMP ENGINEER
HT40-Series Specifications 1.01 GENERAL: The contractor shall provide labor, material, equipment, and incidentals required to provide (QTY) centrifugal pumps as specified herein. The pump models covered in this specification are Series HT40 single phase pumps. The pump furnished for this application shall be model ______________as manufactured by Liberty pumps. 2.01 OPERATING CONDITIONS: Each submersible pump shall be rated at 4/10 hp_____ volts _______ phase 60 Hz. 1550 RPM.
7.01 SEALS The pump shall have a unitized carbon / ceramic seal with stainless steel housings and spring equal to Crane Type 6A. The motor plate / housing interface shall be sealed with a Buna-N oring. 8.01 IMPELLER The impeller shall be a high temperature engineered polymer, with ¾” solids handling capability. It will have pump out vanes on the back shroud to keep debris away from the seal area, and it shall be threaded to the motor shaft. 9.
